The characteristics of the experimental electric furnace:

Muffle Furnace
- Box Furnace
- Bell Furnace
- Crucible Furnace
- Trolley Furnace
- Atmosphere Furnace
Tube Furnace
Vacuum Furnace
- Fiber Vacuum Furnace
- Heat Shield Vacuum Furnace
- Graphite Vacuum Furnace
- Vacuum Hot Pressing Furnace
- Vacuum Carbon Tube Furnace
Accessory For Heating Furnaces

Leave Message

All products are customizable, leave message immediately, we will reply as soon as possible.

The characteristics of the experimental electric furnace:

1. Natural air insulation type, light and easy to carry.
2. The heating speed is fast, and it only takes about 30 minutes to heat up to 1100 °C.
3. The two sides of the furnace are heated by radiation, and the temperature distribution is uniform.
4. Temperature control: PID automatic control LED digital display.
5. Insulation: Imported high temperature resistant ceramic cotton insulation and triple insulation of ceramic plate and high aluminum cotton.
6. Heater: KANTHAL heater imported from Sweden is durable, stable in temperature rise and fast in heating speed.
7. The interior is made of high-temperature resistant ceramic plate, which is not easy to be deformed. The exterior is made of galvanized and high-temperature baking paint, which is beautiful and not easy to fall off the paint.

Production method: Atmosphere protection intermittent production
Heating method: electric heating Calcined product: powder material Operating temperature: 60℃—1700℃ Temperature control accuracy: ≤±1℃

Classification of experimental electric furnaces:
Box electric furnace: 1100℃, 1200℃, 1400℃, 1600℃, 1700℃
Atmosphere box type electric furnace: 1200℃, 1400℃, 1700℃
Vacuum tube furnace: 1100℃, 1200℃, 1400℃, 1500℃, 1700℃
For more needs, please contact us for customization.

Notice:
1. Except for experiments, do not stay in the high temperature furnace tube area.
2. When the experimental work is completed, if no one continues to use it, please turn off the special gas and keep the flow of N2.
3. When handling HF, please wear gloves. If you accidentally touch HF, please flush it immediately, add 2% water with calcium gluconate, and rub the rubbed 15'.
4. Please use quartz glass products with care to avoid breaking and causing serious cuts.
5. Avoid inhaling various gases from the furnace or treatment tank.
6. Potassium cyanide (KCN) cannot be mixed with acids, because both can produce highly toxic KCN gas. 7. Once you find something that hinders safety, please notify the relevant personnel (technician, etc.) immediately. 8. Please save the amount of pure water.
9. Broken wafers, filter paper, cotton swabs, etc., do not fall into the drainage holes at the bottom of the cleaning tank to avoid waterlogging on the floor due to poor drainage.
10. The front end of the long and short push rods should face upwards when not in use to avoid contamination.
11. When the wafer enters and leaves the furnace mouth, take the holder of the boat, do not touch the furnace tube mouth, so as not to contaminate the furnace tube.

NEWS

Product

Contact Us

Leave Message

The characteristics of the experimental electric furnace:

Please leave your requirements

Contact

Products