Zhengzhou Protech
Zhengzhou Protech
Home > Products > Coating Equipment > CVD System
High Temperature Tube Furnace System
model:PT-T1600-L10030-LC4

High Temperature Tube Furnace System

    Application:  High pressure 1600 ℃ vacuum tube furnace, with the possibility of working under atmospheres and under vacuum using inert gases, this furnace is mainly used for the recovery of gases from calcination.
Contact us for customize send-email: info@lab-furnace.com
Zhengzhou Protech Zhengzhou Protech
Detailed Parameters Of The Product
Brief Introduction:  
PT-T1600-L10030-LC4 is a compact tube furnace system, which consists OD100single-zone tube furnace, 4 channels precision mass flow meter with gas mixing tank, and rotary vane vacuum pump system. 
 
Technical Parameter:
Model PT-T1600-L10030-LC4
                  Part I: Tube Furnace
Tube Furnace
 
 
 
Display 7’’ Touch screen
 
Furnace Structure Split type and upper part can be opened.
Double layer steel casing with air cooling to keep furnace surface temperature lower than 60°C. High purity fibrous alumina insulation for Max. energy saving.
Max. Temperature 1600℃ for short time
Continuous Woking Temp. ≤1500℃
Heating Rate Suggestion: 0~10℃/min (max. 20℃/min)
Temperature Zone Double zones
220+220mm
Heating Element MoSi2 rods
Thermocouple B type
Temperature Control Accuracy ±1℃
Processing Tube OD80 x 1000mm (OD x L)
Material:  High pure Alumina
Flanges Flanges made of 304SS
Gas valve and pressure gauge on left flange
Vacuum angle valve with KF25 connector on the right flange
  Two fibrous ceramic blocks are included for blocking heat radiation from inside tube (Ceramic blocks must be fully inserted into the furnace chamber before heating).
 
Temperature Controller -Two temperature controllers control the heating zones separately.
-PID automatic control via SCR (Silicon Controlled Rectifier) power control
-30 programmable segments for precise control of heating rate.
-Built-in over temperature alarm and protection allows for operation without an attendant.
-Furnace with R&S485 communications port and software, which can control on the computer
Power 220V, 50 Hz, single- phase(or according to your requirement) 
max.8KW
Part II:  4 Channels Mass Flow Meter and Controllers
Gas Mass Flow Meter
 
 
 
 
 
 
(touch screen is optional)
4 precision mass flow meters :
MFC 1: Gas flow range from 0~100 sccm   
MFC 2: Gas flow range from 0~500 sccm     
MFC 3: Gas flow range from 0~500 sccm
MFC 4: Gas flow range from 0~1000 sccm    
Please inform us the gas type and measuring range before place order.
Flowing rate accuracy: ±1% FS
One gas mixing tank is installed on bottom case with liquid release valve
4 stainless steel needle valves is installed on left side of bottom case to control 4 type gases mixing manually
Part III: Vacuum Pump system
Vacuum Pump System
 
Rotary Vane Vacuum Pump
Include KF25 Adpater, bellow for vacuum pump and cart with wheel 
Ultimate vacuum 10-3 Torr. And vacuum inside the tube is around 10-1 Torr.
Flow rate: 2.2L/S

 
Part IV: Water cooling system
Water chiller
 
Water cooling on the flange is mainly for cooling down the o-ring inside the flange to ensure the best-sealed chamber at high temperature:
Water cooling flanges require >= 10L/M water flow.

Product

Zhengzhou Protech

After-sales serveces

After-sales serveces
livechat